To Mount on Wall:
• DO NOT remove the tape holding the spring-belts in place.
• Hold the lower template against the wall in the desired location.
• Level the bottom edge.
• Temporarily attach the template to the wall using the marked screw holes in the template. Partially screw in the screws.
• Hold the top template against the lower one lining up the left hand edges. Mark the screw holes.
• Remove the templates from the wall.
• Install wall anchors in the marked holes if necessary.
• Screw the left hand side of the sculpture to the wall using the marked holes. Be careful not to dislodge the strings from the pulleys. Leave the tape in place until the sculpture is fully mounted.
• Screw the right hand side of the sculpture to the wall using the marked holes and in the orientation shown.
• Take the spring belt located in the directions packet and place it around the pulley of the front of the left side of the sculpture and then over and around the middle pulley on the right hand side. Hook the ends of the belt together.
• Make sure the belt goes over the brass pin on the front of the left side.
• Remove the tape holding the strings to the upper mechanism.
• Remove the tape holding the spring-belts in place.
