To Mount on Wall:
• DO NOT remove the tape holding the spring-belts in place.
• Hold the mounting template in the desired location against a wall. The diagram below shows the relationship of the template to the sculpture to guide you in positioning the sculpture on the wall. Minimum clearance distances are noted.
• Level the bottom edge. Use a level.
• Place a sharp instrument through the screw holes, marking their positions on the wall. Remove and save the template.
• Drill pilot holes. If the wall is sheetrock or plaster use plastic anchors.
• The top assembly must be installed in the correct orientation.
There is an arrow on the back of the disk showing the UP side. When
viewed from the front the single short brass pin mounted directly in
the dark circular base should be at between 11 and 12 o’clock.
• Screw the sculpture to the wall.
• Remove the tape holding the drive belt in place.