To Mount on Wall:
• DO NOT remove the tape holding the spring-belts in place.
• Hold the mounting template in the desired location against a wall. The diagram below shows the relationship of the template to the sculpture to guide you in positioning the sculpture on the wall. Minimum clearance distances are noted.
• Level the bottom edge. Use a level.
• Place a sharp instrument through the screw holes, marking their positions on the wall.
• Drill pilot holes. If the wall is sheetrock or plaster use plastic anchors.
• The top assembly must be installed in the correct orientation.
There is an arrow on the back of the disk showing the UP side. When
viewed from the front the single short brass pin mounted directly in
the dark circular base should be at between 11 and 12 o’clock.
• Screw the sculpture to the wall.
• Install the connecting belt by looping it over the small pulley
next to the base on the upper mechanism and the right hand pulley on
the lower mechanism. Hook the ends of the belt together.
• Remove the tape holding the drive belt in place.