Fiesta Installation Directions:

To Mount on Wall:

•   DO NOT remove the tape holding the spring-belts in place.

•   Hold the mounting template in the desired location against a wall.  The diagram below shows the relationship of the template to the sculpture to guide you in positioning the sculpture on the wall. Minimum clearance distances are noted.

•   Attach the template to the wall with 1 screw in the upper right corner screw hole.

 

•   Level the bottom edge of the template. Important! Use a level. Insert a second screw to mark the location.

•    Place a sharp instrument through all the screw holes, marking their positions on the wall. Remove and save the template. You will need it whenever you move the sculpture.

•   Drill pilot holes in the wall.  If the wall is sheet rock or plaster use plastic anchors.

•   Screw the sculpture to the wall. Fiesta is attached in parts and it is important to assemble in the correct order. First attach Base A to the wall with both the upper and lower screws. Refer to the diagram above for base labels.

•   Then attach Base B with only the middle screw.  Do not tighten and once this screw is in place pivot Base B behind the upper lip on Base A. The upper screw hole in Base B will align with the previously drilled hole.

•   Tighten the middle screw and insert and tighten the upper screw in Base B.

•   Take the spring belt located in the directions packet and loop it around the smaller inner pulley of the right, light control wheels. Hook the small hooks on the end of the spring belt together to make a continuous loop.

•   Ease the belt into the slot around the winding wheel at the bottom.

•   Remove the tape holding the spring-belts in place.
•   Note: The sculpture ships with the longer belt in place.  Directions for re-installing it are below in case it is knocked off during shipping or installation.