• Two spring-belts power and control the motion of this sculpture. The short belt is attached during the installation process. The long belt should be taped in place when you receive your sculpture. Below are instructions for reinstalling the longer belt if it should become disconnected during shipping or use. It does take a more involved path and can be a challenge to reinstall without the proper directions.
• Spring-belts tend to have minds of their own and it sometimes helps to have an extra pair of hands to install the long one.• Place the long belt over the small pulley to the rear of the patterning wheels. Bring the right side of this belt to the right and around from back to front of the dark reversing pulley on the upper side of the control wheels and then back and over, from right to left, the small pulley on the front of the patterning wheels. Keep tension on the belt by gently pulling down on the free loop end with your left hand.
• While keeping tension on the belt by holding the free end in one hand, pass the front and back sides of the belt over the pair of control wheels making sure the belt properly aligns with the slots of the wheels. Hold the belt in place against the control wheels with your right hand. With your left hand stretch the free loop of the belt up and over the dark reversing wheel on the right, lower side of the sculpture.
• Reinstall the shorter drive belt. Loop it around the smaller inner pulley of the right, light wheels. Hook the small hooks on the end of the spring belt together to make a continuous loop.• Ease the belt into the slot around the winding wheel at the bottom.